User Manual

You cannot permanently engage a loop when Flux mode is active. The loop only remains
engaged for as long as you hold the Loop encoder and turns off again when released.
Adjustments to loop size can be made whether a loop is engaged or not.
Moving the Playhead
When a loop is inactive, the Loop encoder can also be used for moving the playhead in incre-
ments of the Loop size by holding SHIFT and then turning the loop encoder.
4.2.9 DECK Button
The DECK button allows you to switch the focus (and controls) between the primary and secon-
dary Decks in a Deck section.
DECK Button
The DECK button lights blue when a primary Deck (A or B) is focused and white when the sec-
ondary Deck (C or D) is focused.
4.3 The FX Unit
Above the Decks, the S5 features two FX Units which can be assigned to any of the Decks.
Four knobs and buttons per FX Unit allow you to control effects parameters in real time. Just
like in the software, FX Unit 1 is located in the top-left corner, FX Unit 2 in the top-right.
Hardware Reference
The Deck
TRAKTOR KONTROL S5 - Manual - 162