User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
3.8 Adding FX
In this tutorial section, we will walk you through the basics of using the FX Units. By default,
TRAKTOR provides you with control over two FX Units, which can be assigned to any of the
Decks. You can set up two types of FX: Single FX and Group FX. The following sections will
explain both.
With a second TRAKTOR KONTROL D2 controller you can enhance the full potential of
TRAKTOR and your mixing abilities due to simultaneous control of all Decks and FX
Units.
3.8.1 Assigning Decks to the FX Units
The FX Unit at the top of the D2 controls either FX Unit 1 or FX Unit 2 of the TRAKTOR soft-
ware. This depends on the current Deck control:
▪ When the Deck control is currently on Decks A and C, the FX Unit controls FX Unit 1 of the
TRAKTOR software.
▪ When the Deck control is currently on Decks B and D, the FX Unit controls FX Unit 2 of the
TRAKTOR software.
To assign the Decks A and C to the active FX Unit:
►
Press the FX Assign buttons A and C. The buttons light up brightly.
To unassign the Decks A and C to the active FX Unit:
Using Your D2—Getting Advanced
Adding FX
TRAKTOR KONTROL D2 - Manual - 94