User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
Prerequisites
We assume here that the D2 is in the following state:
▪ The track “Techno 1” is loaded on Deck A and stopped.
Enabling Flux Mode
To enable Flux mode within HOTCUE mode, LOOP mode, or FREEZE mode on Deck A:
1. Press the PLAY button to start playback.
2. Press the FLUX button to enable FLUX mode. The button lights up in orange.
3. Perform on the pads as usual. As soon as a pad is released, playback continues at the
second Playhead's position to preserve the musical phrasing.
4. Press the FLUX button again to exit FLUX mode.
Note that when the FLUX button is engaged, you cannot make use of Slicer mode on the
pads.
Perform a backspin effect for two Beats using FLUX mode
If the option Touch to Scratch is enabled in the TRAKTOR Preferences you can perform a
backspin effect for two beats by using FLUX mode:
1. Press the FLUX button to enable FLUX mode.
2. Hold the SHIFT button, and swipe quickly from the very right to the very left on the Touch
Strip.
3. Two beats later, release the SHIFT button.
→
The Backspin will stop and normal playback will resume right on the beat you desire.
Using Your D2—Getting Advanced
Using FLUX Mode
TRAKTOR KONTROL D2 - Manual - 76