User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
3.3.1 Looping with Pre-defined Sizes
In LOOP mode, with the first row of pads you can engage loops with pre-defined values. By
default, these are (from left to right) 1/8, 1/4, 1/2 or 1 beat.
To engage a loop:
1. Press the PLAY button to start playback.
2. Press the LOOP button to enable LOOP mode.
The LOOP button lights up brightly and the pads also illuminate.
With a track playing and Loop mode enabled, you can perform the following actions:
►
Press one of the green pads to engage a Loop of 1/8 beat, 1/4 beat, 1/2 beat, or 1 beat.
The LED ring around the Loop encoder starts to rotate indicating a loop is engaged.
►
Press the same green pad again or press the Loop encoder to disengage the Loop.
►
While a loop is engaged, rotate the Loop encoder to alter the Loop's size. This will pro-
duce some interesting sound variations.
Using Your D2—Getting Advanced
Playing with Loops in LOOP Mode
TRAKTOR KONTROL D2 - Manual - 64