User Manual

On State Brightness: sets the brightness level for engaged buttons and pads.
Dim State Percentage: sets the brightness level for inactive buttons and pads.
5.6 Loop Mode Sizes
When a Deck is in Loop Mode, the corresponding pads are split into two rows. The top row rep-
resents four Loop sizes, and the bottom row four Beatjump sizes. Here, you can adjust these
settings to suit your needs.
▪ Loop: For each of the upper four pads, you can select a Loop size of: 1/32, 1/16, 1/4, 1/2,
1, 2, 4, 8, 16, 32 beats via drop-down menus.
▪ Beatjump: For each of the four lower pads you can select a Beatjump size of: - LOOP, - 32,
- 16, - 8, - 4, - 2, - 1, -/2, -/4, -/8, -/16, +/16, +/8, +/4, +/2, +1, +2, +4, +8, + 16, + 32,
+LOOP.
5.7 Enable MIDI Controls
The TRAKTOR KONTROL D2 allows you to use the Performance Knobs, Performance Buttons,
and the Performance Faders below the Display as MIDI output controls. You can use these
controls to send MIDI messages to other software or external equipment. This feature is not
enabled by default and requires some configuration.
Enabling MIDI Controls
To enable MIDI Controls for the D2:
1. In the TRAKTOR window click File, then Preferences to open the preferences window.
2. Navigate to the Traktor Kontrol D2 page. There, check the Enable MIDI controls prefer-
ence in the MIDI Controls section.
Preferences Pane in TRAKTOR
Loop Mode Sizes
TRAKTOR KONTROL D2 - Manual - 204