User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
▪ Bend Invert: by default deactivated; swiping to the left slows playback down momentarily.
If activated, swiping to the left nudges playback forward.
▪ Scratch Invert: by default activated; swiping to the left advances playback position in the
track. If deactivated, swiping to the left goes back in a track.
▪ Shift + Touch to Scratch: by default deactivated, holding the SHIFT button +swiping within
the Touch Strip performs an absolute seek. If activated, holding the SHIFT button +swip-
ing within the Touch Strip performs a scratch effect or backspin.
5.4 Calibrate
Calibration ensures that each control allows adjustments over their full range and with maxi-
mum precision. These settings are precisely calibrated during production, although they might
need to be recalibrated over the lifetime of your D2 unit. Recalibration is necessary when a
control ceases to allow you to set actual minimum and maximum values.
Calibration is done in groups of control elements, just click the corresponding Recalibrate but-
ton:
▪ FX Knobs: for recalibrating the FX knobs on both FX Units 1 and 2.
▪ Short Faders: for recalibrating the Slot Volume Faders.
▪ FX Knobs: for recalibrating the FX knobs on both FX Units 1 and 2.
▪ Mixer Knobs: for recalibrating EQ (HI, MID, LOW) and FILTER knobs.
▪ Mixer Faders: for recalibrating the channel faders.
▪ Crossfader: for recalibrating the Crossfader.
5.5 LEDs
The pad and button backlights on the D2 offer two distinct brightness levels to indicate On
and Off states. Depending on your light conditions during a performance, it can be necessary
to adjust these.
Preferences Pane in TRAKTOR
Calibrate
TRAKTOR KONTROL D2 - Manual - 203