User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
Performance Controls
Performance Mode FILTER
The default Performance Mode for a Remix Deck is FILTER. The Performance ON buttons are
used to engage/disengage a Remix Slot's FILTER. The FILTER cutoff is controlled by the corre-
sponding Performance knob. Adjustments to FILTER cutoff are shown via the Performance
pop-up at the lower end of the displays.
The Performance Controls work even if the Remix Deck isn't focused.
Performance Mode FX SEND
When FX SEND is selected, the knobs control the amount of signal being sent to the assigned
FX Unit(s), per Slot. The FX SEND amount is displayed right above the corresponding Perform-
ance knob.
In case you increase FX SEND and still don't hear any effect, please make sure the Re-
mix Deck is actually assigned to an FX Unit in the corresponding Mixer channel.
Performance Mode PITCH
When PITCH is selected, the Performance knobs transpose the pitch of the playing sample. In
other words: pitch correction is applied per Remix Cell. The amount of pitch change is dis-
played above the corresponding knob.
Hardware Reference
The Deck
TRAKTOR KONTROL D2 - Manual - 193