User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
4.4.2 USB Connector
USB Connector
Connect D2 to your computer here, using the included USB cable. The connection is USB 2,
but is compatible to USB 3-equipped computers.
Due to the large amounts of data transmitted to the TRAKTOR KONTROL D2, it may not
work properly when connected to a USB hub. Make sure to connect D2 directly to a
USB port on your computer if possible.
4.4.3 POWER Section
POWER Section
In the POWER section, you make the connection to the power supply and to your computer:
(1) Power Supply connector (15V - 2.66 A): connect the included power supply.
(2) ON/OFF switch: press this switch to turn your device on or off.
Hardware Reference
The Rear Panel
TRAKTOR KONTROL D2 - Manual - 179