User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
Position-aware Beatgrid Tempo Adjustment
Performance knobs 3 and 4 (BPM) are scaled based on the viewing position of Beatgrid mode
so that adjustments made far away from the Beatmarker don’t result in abrupt changes to the
waveform position. For example, if you are near the Beatmarker at the start of a track and
change the tempo of the Beatgrid, you will see the waveform move under the Beatgrid by a
particular amount. If you then scan later into the track, adjusting the tempo will create a simi-
lar amount of motion on the waveform (rather than a large amount of motion) thus allowing for
precise setting of the Beatgrid tempo over the length of the track.
Beatgrid Zoom Mode
To set the position of the Beatgrid with greater precision you can use the Beatgrid Zoom mode:
1. Press the ON button 1 to zoom in the first beat.
2. Rotate Performance knob 3 and 4 to adjust the Beatgrid.
3. Press the ON button 1 again to exit Beatgrid Zoom mode.
3.12.3 Additional Help Actions
Tap the Tempo
Tap allows you to manually set the tempo by tapping along the playing track:
Using Your D2—Getting Advanced
Working with Beatgrids
TRAKTOR KONTROL D2 - Manual - 143