User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
►
When BPM is selected rotate the LOOP encoder to correct the detected BPM value in
coarse steps. Try to align the second, third and fourth beat (in most cases indicated by
the biggest peaks in the waveform) with the second, third and fourth Beatmarker.
►
When FINE is selected rotate the LOOP encoder to correct the detected BPM value in
fine increments (.01 BPM).
►
When SCAN is selected rotate the LOOP encoder to scroll through the track. Check if the
Beatgrid stays aligned over the course of the track.
Using Your D2—Getting Advanced
Working with Beatgrids
TRAKTOR KONTROL D2 - Manual - 142