User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
Applying FX SEND to Stem Parts
You can also apply FX SEND to any of the Stem Parts.
To apply the FX Unit’s FX to Stem Parts:
1. Assign the Stem Deck to the active FX Unit.
2. Press the Performance Mode buttons until the FX SEND page is selected in the Perform-
ance Mode pane.
3. Press the ON buttons to apply the FX of the active FX Unit to the Stem Parts.
Using Your D2—Getting Advanced
Mixing Stem Files using Stem Decks
TRAKTOR KONTROL D2 - Manual - 133