User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
2. Turn the Performance knobs clockwise to increase or counterclockwise to decrease the FX
SEND amount.
→
You can hear a Reverb effect being added to the Remix Slots. Slot 1's value of 25%
means that you're listening to a mix of 75% unprocessed signal and 25% Reverb.
3.10 Using Step Sequencer Mode on Remix Decks
This sub-section describes the usage of Step Sequencer mode with the TRAKTOR KONTROL
D2.
The Step Sequencer mode is dedicated to the Remix Decks and allows you to program a pat-
tern to be played by the focused sample on any Remix Slot. The amount of steps of the indi-
vidual sequences can be defined between 1 and 16 steps. The default amount is set to 8
steps. The Step Sequencer is meant to be used with one-shot samples such as kick, snare, hi-
hat, sound FX, etc. The usage of loops works too, but may not bring appropriate results.
Overview of Step Sequencer Mode in the Display
When Step Sequencer Mode is active, the display of TRAKTOR KONTROL D2 controller shows
the following appearance:
Using Your D2—Getting Advanced
Using Step Sequencer Mode on Remix Decks
TRAKTOR KONTROL D2 - Manual - 112