User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL D2!
- Using Your D2—Getting Started
- Using Your D2—Getting Advanced
- Using Touch Strip
- Playing with Loops in HOTCUE Mode
- Playing with Loops in LOOP Mode
- Using FREEZE Mode
- Using FLUX Mode
- Remixing with Remix Decks
- Capturing Samples from Track Decks (Using Remix Mode)
- Adding FX
- Using Performance Modes on Remix Decks
- Using Step Sequencer Mode on Remix Decks
- Mixing Stem Files using Stem Decks
- Working with Beatgrids
- Hardware Reference
- Preferences Pane in TRAKTOR
- Troubleshooting - Getting Help
- Technical Specification
3.8.4 Setting up an FX Unit in Single FX Mode
While a Group FX setup gives you control over up to three effects with one parameter each,
setting an FX unit to Single mode provides access to three parameters of a single effect.
We will set up FX Unit 2 in Single FX mode and load a Delay effect:
Prerequisites
▪ The D2 controls the right Decks B and D so that the FX Unit of the D2 controls FX Unit 2
of the TRAKTOR software.
▪ The track "Techno 2" is loaded into Deck B. The track is playing and audible.
To load a Single FX to FX Unit 2:
1. Press the FX SELECT button in the top right of the D2.
FX Unit 2's setup menu opens in the display.
2. Press FX Button 1 to display the FX Unit 2 options.
Using Your D2—Getting Advanced
Adding FX
TRAKTOR KONTROL D2 - Manual - 101