User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- 1 Welcome to the World of TRAKTOR KONTROL S2!
- 2 TRAKTOR KONTROL S2 Quick Overview
- 3 Preparing Your Music Library
- 4 Tutorials
- 4.1 Playing Your First Track
- 4.2 Mixing In a Second Track
- 4.2.1 Loading and Playing the Second Track
- 4.2.2 Using Headphones to Prepare the Mix
- 4.2.3 Synchronizing the Second Track
- 4.2.4 Setting a Cue Point as Starting Point
- 4.2.5 Interlude: In Case the Left Track Has Reached Its End
- 4.2.6 Mixing In the Track by Using the Channel EQ and Filter
- 4.2.7 Doing Everything by Hand
- 4.3 Adjusting Levels
- 4.4 Looping and Cueing
- 4.5 Using Samples in Your Mix
- 4.6 Adding FX
- 4.7 Synchronization
- 5 Using the S2 with TRAKTOR DJ
- 6 Hardware Overview
- 7 Hardware Control Reference
- 8 Customizing TRAKTOR KONTROL S2
- 9 The S2 Audio Interface and Control Panel
- 10 Troubleshooting and Help
- 11 Appendix A – Common Setups
- 12 Appendix B – Technical Information
- 13 Appendix C – Quick References
- Index
Triggering a loop in TRAKTOR DJ using the Loop SIZE encoder.
Storing Loops Using the S2
When you find those of so perfect sections of your track's to loop, you can use the S2 to store
these by:
►
With the Loop mode engaged, press an available (i.e. non backlit) Hotcue button.
→
The selected Hotcue button is now backlit green to indicate a loop is stored.
To delete any stored cue points, loops etc., hold the SHIFT button whilst pressing the Hot-
cue button you wish to delete. The button will no longer be backlit.
Loop Slicer Mode
1. Follow the instructions below to understand how to engage TRAKTOR DJ's Loop Slicer.
2. Trigger a loop on your chosen deck, using either the Loop SIZE encoder or manually via
the LOOP IN/OUT buttons.
Using the S2 with TRAKTOR DJ
Using the Transport Section
Traktor Kontrol S2 - Manual - 78