User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- 1 Welcome to the World of TRAKTOR KONTROL S2!
- 2 TRAKTOR KONTROL S2 Quick Overview
- 3 Preparing Your Music Library
- 4 Tutorials
- 4.1 Playing Your First Track
- 4.2 Mixing In a Second Track
- 4.2.1 Loading and Playing the Second Track
- 4.2.2 Using Headphones to Prepare the Mix
- 4.2.3 Synchronizing the Second Track
- 4.2.4 Setting a Cue Point as Starting Point
- 4.2.5 Interlude: In Case the Left Track Has Reached Its End
- 4.2.6 Mixing In the Track by Using the Channel EQ and Filter
- 4.2.7 Doing Everything by Hand
- 4.3 Adjusting Levels
- 4.4 Looping and Cueing
- 4.5 Using Samples in Your Mix
- 4.6 Adding FX
- 4.7 Synchronization
- 5 Using the S2 with TRAKTOR DJ
- 6 Hardware Overview
- 7 Hardware Control Reference
- 8 Customizing TRAKTOR KONTROL S2
- 9 The S2 Audio Interface and Control Panel
- 10 Troubleshooting and Help
- 11 Appendix A – Common Setups
- 12 Appendix B – Technical Information
- 13 Appendix C – Quick References
- Index
To Each Deck Its Own Channel
The audio playing on each Deck can be further shaped by the controls on the corresponding
channel of the Mixer. Since the track is loaded on Deck A, you can control its sound on chan-
nel A (the left Mixer channel):
The Channel A.
At this point you will probably hear some audio coming through your speakers or PA. If not,
please check the following section.
4.1.3
If You Don’t Hear the Track
If the track is playing on the Deck but the audio coming through your amplification system
sounds too low, or if there is no sound at all, check the following:
Tutorials
Playing Your First Track
Traktor Kontrol S2 - Manual - 28