User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- 1 Welcome to the World of TRAKTOR KONTROL S2!
- 2 TRAKTOR KONTROL S2 Quick Overview
- 3 Preparing Your Music Library
- 4 Tutorials
- 4.1 Playing Your First Track
- 4.2 Mixing In a Second Track
- 4.2.1 Loading and Playing the Second Track
- 4.2.2 Using Headphones to Prepare the Mix
- 4.2.3 Synchronizing the Second Track
- 4.2.4 Setting a Cue Point as Starting Point
- 4.2.5 Interlude: In Case the Left Track Has Reached Its End
- 4.2.6 Mixing In the Track by Using the Channel EQ and Filter
- 4.2.7 Doing Everything by Hand
- 4.3 Adjusting Levels
- 4.4 Looping and Cueing
- 4.5 Using Samples in Your Mix
- 4.6 Adding FX
- 4.7 Synchronization
- 5 Using the S2 with TRAKTOR DJ
- 6 Hardware Overview
- 7 Hardware Control Reference
- 8 Customizing TRAKTOR KONTROL S2
- 9 The S2 Audio Interface and Control Panel
- 10 Troubleshooting and Help
- 11 Appendix A – Common Setups
- 12 Appendix B – Technical Information
- 13 Appendix C – Quick References
- Index
►
Click on the tabs at the left to open the corresponding page of the Control Panel.
9.2.2 Audio Settings Page
The Audio Settings page allows you to adjust the settings of the audio interface.
The Control Panel with Audio Settings page opened.
The Audio Settings page consists of two sections:
▪ Audio Processing: settings for the analog-to-digital/digital-to-analog conversion done by
your audio interface.
▪ Device Monitor: displays information about the audio interface's processing status and
your system's output latency.
Audio Processing Section
The Audio Processing section holds two menus and one display:
▪ Sample Rate : Choose a sample rate that is compatible with your music application and
suited to your computing power. A higher sample rate improves the audio quality, but also
causes higher CPU load. By default, the sample rate is set to 44100 Hz (CD quality).
The S2 Audio Interface and Control Panel
Settings on Windows: The Control Panel
Traktor Kontrol S2 - Manual - 147