User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- 1 Welcome to the World of TRAKTOR KONTROL S2!
- 2 TRAKTOR KONTROL S2 Quick Overview
- 3 Preparing Your Music Library
- 4 Tutorials
- 4.1 Playing Your First Track
- 4.2 Mixing In a Second Track
- 4.2.1 Loading and Playing the Second Track
- 4.2.2 Using Headphones to Prepare the Mix
- 4.2.3 Synchronizing the Second Track
- 4.2.4 Setting a Cue Point as Starting Point
- 4.2.5 Interlude: In Case the Left Track Has Reached Its End
- 4.2.6 Mixing In the Track by Using the Channel EQ and Filter
- 4.2.7 Doing Everything by Hand
- 4.3 Adjusting Levels
- 4.4 Looping and Cueing
- 4.5 Using Samples in Your Mix
- 4.6 Adding FX
- 4.7 Synchronization
- 5 Using the S2 with TRAKTOR DJ
- 6 Hardware Overview
- 7 Hardware Control Reference
- 8 Customizing TRAKTOR KONTROL S2
- 9 The S2 Audio Interface and Control Panel
- 10 Troubleshooting and Help
- 11 Appendix A – Common Setups
- 12 Appendix B – Technical Information
- 13 Appendix C – Quick References
- Index
7.7.5 Crossfader
The crossfader.
The crossfader controls the mix between the signal(s) assigned to its left and right side. At the
center position, the crossfader has no effect: channel levels are then only defined by the re-
spective channel faders (see above). At each crossfader’s end, the opposite signals are totally
cut.
You can customize the fading curve of the crossfader in TRAKTOR’s Preferences. Please
refer to the TRAKTOR 2 Manual for more info.
You can customize the fading curve of the Crossfader in Preferences > Mixer > Crossfader.
Please refer to the TRAKTOR 2 Manual for more info.
7.7.6 Main Section
The Mixer's Main section.
The Main section allows you to both monitor and adjust the overall output level of your mix,
i.e., the level of the signal sent to the Main Outputs on your S2. This is the last step for con-
trolling the level on your S2, before your mix is sent to the outside world.
Hardware Control Reference
Using the Mixer
Traktor Kontrol S2 - Manual - 123