User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- 1 Introduction
- 2 Basic Concepts
- 3 Browser
- 4 Sound Slots
- 5 Creating Groups
- 6 Working with Patterns (Hardware)
- 6.1 Creating Patterns
- 6.1.1 Pattern Mode
- 6.1.2 Pad Mode
- 6.1.3 Pad Link
- 6.1.4 Releasing a Pad from a Pad Link Group
- 6.1.5 Recording the Pads
- 6.1.6 The Metronome
- 6.1.7 Using the Step Sequencer
- 6.1.8 Using Note Repeat
- 6.1.9 Using the Piano Roll/Keyboard
- 6.1.10 Recording Automation
- 6.1.11 Recording Automation in the Step Sequencer
- 6.1.12 Step Grid, Pattern Length Grid and Quantization
- 6.2 Editing Patterns
- 6.1 Creating Patterns
- 7 Working with Patterns (Software)
- 7.1 The Pattern Editor
- 7.2 Editing Patterns
- 7.2.1 Mouse Actions in the Pattern Editor
- 7.2.2 The Zoom Tool
- 7.2.3 Compare/Split
- 7.2.4 The Piano Roll / Keyboard
- 7.2.5 Recording and Editing Automation
- 7.2.6 Adding a Modulator
- 7.2.7 Step Grid, Pattern Length Grid and Quantization
- 7.2.8 Pad Link
- 7.2.9 Releasing a Pad from a Pad Link Group
- 7.2.10 Setting up a Pad as Master or Slave in a Pad Link Group
- 7.2.11 Rendering Audio from Patterns using Drag and Drop
- 7.2.12 Rendering MIDI from Patterns using Drag and Drop
- 8 The Effects Overview
- 9 Using FX
- 9.1 Applying Effects to a Sound
- 9.2 Applying Effects to a Group
- 9.3 Applying Effects to the Master
- 9.4 Bypassing Effects
- 9.5 Automating Effects and Sampler Parameters
- 9.6 Applying FX to an External Instrument
- 9.7 Recording FX Automation
- 9.8 Saving FX Presets
- 9.9 Creating a Send Effect
- 9.10 Creating a Multi Effect
- 10 Creating a Song using Scenes
- 11 Sampling and Sample Mapping
- 12 The Master Section
- 13 Exporting Audio
- 14 Appendix: Tips for playing Live
- Index
2.2.6 Navigating Parameter Pages in the Control Area
In some situations, the Control area consists of more parameters than the displays can show at
once. Examples of this are the Groups’ Output tab (OUT on the controller) and the Sounds’
Source tab (SRC on the controller) if set to Sampler. In these cases, the number of Parameters
is divided into several Parameter pages that you can easily navigate with the hardware and
software.
Hardware
On the MASCHINE hardware controller you can use the Page buttons to navigate through the
Parameter pages. Whenever there is more than one page, it will be shown on the right side of
the right display like this:
The display of available 1/6 pages in a Group Output tab.
Moreover, if there is another page available to the left or to the right of the current page, the
corresponding Page button will be lit on your MASCHINE hardware controller.
Software
On the software you click the Parameter Page selector to navigate through the pages:
The Parameter Page selector in the Control area: first page of parameter settings for Module 1.
Basic Concepts
Common Operations
MASCHINE - Manual - 22