User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- 1 Introduction
- 2 Basic Concepts
- 3 Browser
- 4 Sound Slots
- 5 Creating Groups
- 6 Working with Patterns (Hardware)
- 6.1 Creating Patterns
- 6.1.1 Pattern Mode
- 6.1.2 Pad Mode
- 6.1.3 Pad Link
- 6.1.4 Releasing a Pad from a Pad Link Group
- 6.1.5 Recording the Pads
- 6.1.6 The Metronome
- 6.1.7 Using the Step Sequencer
- 6.1.8 Using Note Repeat
- 6.1.9 Using the Piano Roll/Keyboard
- 6.1.10 Recording Automation
- 6.1.11 Recording Automation in the Step Sequencer
- 6.1.12 Step Grid, Pattern Length Grid and Quantization
- 6.2 Editing Patterns
- 6.1 Creating Patterns
- 7 Working with Patterns (Software)
- 7.1 The Pattern Editor
- 7.2 Editing Patterns
- 7.2.1 Mouse Actions in the Pattern Editor
- 7.2.2 The Zoom Tool
- 7.2.3 Compare/Split
- 7.2.4 The Piano Roll / Keyboard
- 7.2.5 Recording and Editing Automation
- 7.2.6 Adding a Modulator
- 7.2.7 Step Grid, Pattern Length Grid and Quantization
- 7.2.8 Pad Link
- 7.2.9 Releasing a Pad from a Pad Link Group
- 7.2.10 Setting up a Pad as Master or Slave in a Pad Link Group
- 7.2.11 Rendering Audio from Patterns using Drag and Drop
- 7.2.12 Rendering MIDI from Patterns using Drag and Drop
- 8 The Effects Overview
- 9 Using FX
- 9.1 Applying Effects to a Sound
- 9.2 Applying Effects to a Group
- 9.3 Applying Effects to the Master
- 9.4 Bypassing Effects
- 9.5 Automating Effects and Sampler Parameters
- 9.6 Applying FX to an External Instrument
- 9.7 Recording FX Automation
- 9.8 Saving FX Presets
- 9.9 Creating a Send Effect
- 9.10 Creating a Multi Effect
- 10 Creating a Song using Scenes
- 11 Sampling and Sample Mapping
- 12 The Master Section
- 13 Exporting Audio
- 14 Appendix: Tips for playing Live
- Index
This amplitude envelope is mainly meant to allow you to get rid of clicks after slicing; you can
either apply it to the whole Sample or to individual selected Slices.
Screen Element Description
Attack The Attack determines how quickly the Sample/Slice reaches full volume
after being triggered.
Decay Decay is used to adjust how fast the Sample/Slice dies down.
11.1.6 Slicing a Sample
Slicing allows you to chop up Loops to be able to extract single Sounds (the drum sounds of a
drum loop for example), but is also good for preparing a Loop to be played back at another
than the original tempo without changing its pitch or timing.
Drag a Loop or any other long Sample you wish to slice from the Browser (or sample one your-
self!) and drop it in an empty Sound slot. Press the Sampling button and then the SLICE tab.
You can see that your Loop now has a couple of equally spread vertical lines in the waveform:
this is where the Slices are going to be applied. You can select and listen to individual Slices
by clicking on their waveform.
Sampling and Sample Mapping
Controlling Sampling from the Hardware
MASCHINE - Manual - 216