User Manual
Table Of Contents
- _
- Table of Contents
- 1. Disclaimer
- 2. Welcome to TRAKTOR KONTROL S2
- 3. Concepts
- 4. Setting up TRAKTOR KONTROL S2
- 5. TRAKTOR KONTROL S2 Overview
- 6. Mixing Your First Tracks using SYNC
- 7. Tutorials
- 7.1. Browsing and Loading Tracks
- 7.2. Controlling Track Playback
- 7.3. Adjusting Volume Levels
- 7.4. Using the Equalizer to Tweak Your Sound
- 7.5. Adjusting Track Tempo
- 7.6. Locking the Key of Tracks
- 7.7. Playing with Mixer Effects
- 7.8. Playing with Cue Points
- 7.9. Playing with Loops
- 7.10. Snap Mode and Quantize Mode
- 7.11. Using Flux and Reverse Modes
- 7.12. Previewing Tracks using the CUE Channel
- 7.13. Working with the Preparation List
- 7.14. Adding Samples to Your Mix
- 7.15. Correcting Beatgrids of Tracks
- 7.16. Mixing Tracks Using Jog Wheels
- 8. Preferences
- 9. Integrating a Microphone
- 10. Setting the TRAKTOR KONTROL S2 as Your Default Audio Interface
2. Release the GRID button.
The track's Beatgrid is corrected and saved with the track.
7.16. Mixing Tracks Using Jog Wheels
In this section, you learn how to mix your first two tracks using Deck A and Deck B, the Jog
Wheels and your headphones. At first, you will prepare the Mixer by adjusting the control elements
for mixing from Deck A to B. Then you will load the first track into Deck A, and begin to perform
step by step.
7.16.1. Prerequisites
Before you can start to mix your first tracks, you need to prepare the Mixer on your S2:
1. Set the crossfader to the left-most position.
2. Set Channel fader A and Channel fader B to maximum position.
3. Set the MASTER knob to center position.
4. Set the volume of your audio system or active speakers to minimum level.
7.16.2. Loading the First Track into Deck A
To load a track into Deck A:
1. Press the Browser View button to maximize the Browser view in the software.
Tutorials
35