User Manual
Table Of Contents
- _
- Table of Contents
- 1. Disclaimer
- 2. Welcome to TRAKTOR KONTROL S2
- 3. Concepts
- 4. Setting up TRAKTOR KONTROL S2
- 5. TRAKTOR KONTROL S2 Overview
- 6. Mixing Your First Tracks using SYNC
- 7. Tutorials
- 7.1. Browsing and Loading Tracks
- 7.2. Controlling Track Playback
- 7.3. Adjusting Volume Levels
- 7.4. Using the Equalizer to Tweak Your Sound
- 7.5. Adjusting Track Tempo
- 7.6. Locking the Key of Tracks
- 7.7. Playing with Mixer Effects
- 7.8. Playing with Cue Points
- 7.9. Playing with Loops
- 7.10. Snap Mode and Quantize Mode
- 7.11. Using Flux and Reverse Modes
- 7.12. Previewing Tracks using the CUE Channel
- 7.13. Working with the Preparation List
- 7.14. Adding Samples to Your Mix
- 7.15. Correcting Beatgrids of Tracks
- 7.16. Mixing Tracks Using Jog Wheels
- 8. Preferences
- 9. Integrating a Microphone
- 10. Setting the TRAKTOR KONTROL S2 as Your Default Audio Interface
The tempo of the track in Deck B is now synced to the running track, indicated by the equal
tempo value in the software's Deck Header. The SYNC button lights up on Deck B.
6.6. Starting Playback of the Second Track
When the track in Deck A is almost over you can start the playback of the next track:
• Press the Play/Pause button on Deck B to start playback.
The waveform starts moving and the Channel Volume Meter LEDs in Mixer channel B illumi-
nate. The tracks in Deck A and Deck B play in sync.
6.7. Mixing in the Audio Signal
You can now mix the audio signal of Mixer channel B into the Master signal:
1. Move the crossfader slowly towards center position and hold for a moment.
The audio signal of the track in Mixer channel B fades into the Master signal.
2. While the track in Deck A reaches its end, slowly move the crossfader towards the right-most
position.
Mixing Your First Tracks using SYNC
21