User Manual

(6) Mid fader: Adjusts the reverb time for the higher frequency band. The possible values range
from 0.60 to 70.00 seconds. Like Bass, higher values of Mid can lead to infinite reverb
sounds! Of course, this is even more true when increasing both parameters simultaneously.
(7) Crossover knob: Adjusts the split frequency between the lower and higher frequency band.
The possible values range from 100.0 to 10,900.0 hertz. Turn the knob counterclockwise (i.e.
towards the Bass fader) to increase the split frequency, hence widening the frequency band
controlled by the Bass fader. Inversely, turn the knob clockwise (i.e. towards the Mid fader) to
make the Mid fader control a wider frequency band.
(8) HiCut fader: Adjusts the cutoff frequency of a low-pass filter that is applied to the process-
ed signal to attenuate its higher frequencies. The possible values range from 100.0 to
10,900.0 hertz. Notably, cutting the high frequencies of the reverberant sound can make it
sound more natural.
Using RC 24
Adjusting the Reverb Parameters
RC 24 - Manual - 24