User Manual

3.4 Adjusting the Reverb Parameters
In the bottom part of the RC 24 interface you can adjust each single parameter of the reverb
effect. These parameters are arranged into two groups:
▪ Parameters in the left part define general characteristics of the reverb shape. These are
mostly independent of the input signal’s frequency content—in other terms, they affect
the entire incoming signal.
▪ Parameters in the right part allow you to set distinct reverberating behaviors for various
frequency bands of the signal to be processed.
The RC 24 plug-in honors a classic piece of hardware gear by taking over parts of its quite un-
usual set of parameters. For example, there is not one “reverb time” (also called “decay time”)
parameter for the reverb but two: the Bass and Mid faders define decay times for two distinct
frequency bands, whose respective bandwidths can be adjusted via the Crossover knob below.
The reverb parameters: frequency-independent on the left (1–4), frequency-related on the right (5–8).
Using RC 24
Adjusting the Reverb Parameters
RC 24 - Manual - 22