User Manual

(3) Dry/Wet knob: Adjusts the balance between the original, unprocessed (“dry”) signal, and
the processed (“wet”) signal—i.e., the signal onto which the reverb was applied. The Dry/Wet
knob is enabled only if the Wet/Mix switch (2) is set to Mix (if this switch is set to Wet, only
the wet signal is output anyway). At full left (Dry), you hear only the original signal. At full right
(Wet), you hear only the processed, reverberated signal.
3.3 Using the Display
The middle part of the RC 24 interface holds a powerful, yet intuitive, multi-purpose display.
This tool can be used both to visually monitor how the reverb affects the signal, and to further
shape the effect. The display provides two pages:
▪ The Spectrum page displays a graphic representation of how the reverb affects the input
signal. Optionally, you can superimpose a live representation of the input signal being
processed by the reverb—see the description of the Options page below.
▪ The Options page provides a few more parameters affecting the display and the reverb ef-
fect.
Either page can be enabled by clicking the corresponding tab at the top of the display, as de-
scribed below.
3.3.1 Common Controls
At the top of the display, you always find the same three elements: the Spectrum and Options
tabs, and the Level meters. The other elements in the display depend on the selected page.
Using RC 24
Using the Display
RC 24 - Manual - 16