User Manual

▪ The upper part (above the display) holds a few controls affecting the overall behavior of
the reverb unit.
▪ The middle part holds the multi-purpose display.
▪ The bottom part holds the faders and knobs allowing you to finely adjust the characteris-
tics of the reverb.
For all knobs and faders, the value is displayed in place of the control label when the
mouse cursor hovers over the control, or when you are interacting with the control.
The following sections describe each of these areas.
3.1 The Menu Bar
At the very top of the RC 24 interface, you will see the Menu bar. This is primarily used for
saving and loading presets, but also has a few other functions.
The Menu bar is located at the top of the interface.
3.1.1 Loading Presets
In the center part of the Menu bar, you will see the Preset menu. This menu provides quick
access to all available presets for your effect.
To load presets, either:
►
Click the left and right arrows at the left of the Preset menu to cycle through and load the
presets one at a time, or
►
Click the Preset menu (displaying the name of the loaded preset) to display a structured
list of all available presets, navigate through the preset folders, and click the desired pre-
set to load it. See below for a detailed description of the Preset menu.
In Demo mode you cannot load user presets! Presets saved in Demo mode will be available
once you have activated your effect (see section ↑2.2, Activating RC 24 for more on this).
Using RC 24
The Menu Bar
RC 24 - Manual - 10