User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the TRAKTOR KONTROL F1!
- TRAKTOR KONTROL F1 Overview
- Tutorials and Workflows
- TRAKTOR KONTROL F1 Reference
- Introduction
- Performance Mode
- Browse Mode
- Capture Mode
- Selecting the Capture Source Deck
- Activating Capture Mode
- Setting the Capture Size
- The SYNC (MASTER) Button in Capture Mode
- Activating a Loop on the Capture Source Deck
- Loop Move and Beat Jump on Capture Source Deck
- Capturing a Sample into a Cell
- Auto-capturing a Sample
- Quick-Capturing Into a Cell
- Quick Auto-Capture
- Delete Mode
- Color Mode
- Type Mode
- Pitch Mode
- Size Mode
- Speed Mode
- Edit Mode
- MIDI Mode
- Sample Slot Parameters
- F1 Preferences
- Index
4.4.3 Setting the Capture Size
Once you have activated Capture mode, you can change the capture length with the encoder
knob:
►
With Capture mode active, rotate the encoder knob to set the capture size.
When pressing the encoder knob at this point, a loop of the specified length will be activat-
ed in the capture source Deck. Pressing the encoder knob again will deactivate the loop.
Activating a loop inside the Track Deck before capturing can be handy for transitions be-
tween elements of a Remix, or between track transitions in your mix.
The available capture length values can be seen on the table above. The Display shows the
current capture length value.
4.4.4 The SYNC (MASTER) Button in Capture Mode
When Capture mode is active, the SYNC (MASTER) button will both control and indicate the
Sync and Master states of the capture source Deck. This is mostly for the case where you real-
ize that the capture source Deck is not synced to the Master. It gives you an opportunity to
sync the Deck without having to take your hands of the controller; for example, if Sync is on for
the Remix Deck but Sync is off for the capture source Deck, the SYNC (MASTER) button will
turn dim when you activate Capture mode — this shows you that the capture source Deck is
not synced to the Master.
►
If you press the SYNC (MASTER) button, Sync will be enabled on the capture source
Deck and the button will light up brightly.
►
Using the SHIFT button, you can do the same with the Master state of the capture source
Deck: in Capture mode, the SYNC (MASTER) button will be dim if the capture source
Deck is not the Master. By pressing the button (while holding SHIFT), you can toggle the
Master state of the capture source Deck.
4.4.5 Activating a Loop on the Capture Source Deck
►
By pressing the encoder knob, you can activate or deactivate the Loop.
When the Loop is active, the Loop Size will blink on and off on the display.
TRAKTOR KONTROL F1 Reference
Capture Mode
TRAKTOR KONTROL F1 - Manual - 87