User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the TRAKTOR KONTROL F1!
- TRAKTOR KONTROL F1 Overview
- Tutorials and Workflows
- TRAKTOR KONTROL F1 Reference
- Introduction
- Performance Mode
- Browse Mode
- Capture Mode
- Selecting the Capture Source Deck
- Activating Capture Mode
- Setting the Capture Size
- The SYNC (MASTER) Button in Capture Mode
- Activating a Loop on the Capture Source Deck
- Loop Move and Beat Jump on Capture Source Deck
- Capturing a Sample into a Cell
- Auto-capturing a Sample
- Quick-Capturing Into a Cell
- Quick Auto-Capture
- Delete Mode
- Color Mode
- Type Mode
- Pitch Mode
- Size Mode
- Speed Mode
- Edit Mode
- MIDI Mode
- Sample Slot Parameters
- F1 Preferences
- Index
5.1.3 LEDs
You can adjust the brightness of both states of your F1's LEDs in this section.
The LEDs section.
• On State Brightness: Sets the brightness for the On state of the LEDs.
• Dim State Brightness: Sets the brightness for the Dim state of the LEDs. This value is ex-
pressed as a percentage of the On state brightness.
5.1.4 MIDI Mode
These buttons determine what will happen when you press SHIFT+ BROWSE (MIDI) on the F1.
The MIDI Mode section.
• If you have MIDI Mode selected here, pressing SHIFT + BROWSE [MIDI] will switch the
F1 into ordinary MIDI mode.
• If User Map is selected, pressing SHIFT + BROWSE (MIDI) will not enter MIDI mode. In-
stead, it will load the User Mapping for the F1, thus, allowing you to quickly access your
own User Map, which still has support for the RGB LEDs and takes advantage of the high-
resolution controls on the F1 (which are transmitted via NHL rather than MIDI). See the
"Controller Manager" chapter from the TRAKTOR 2 Manual for more information on User
Maps.
Also have a look at ↑4.12, MIDI Mode for further information on the difference between
MIDI mode and User Map mode.
F1 Preferences
The F1 Preferences Section
TRAKTOR KONTROL F1 - Manual - 122