User Manual

Master and Drum specific EQ.
► If two switches are offered, you can tab between the EQ controls by clicking on the la-
bel.
► To select a drum or loop for editing, just hit the corresponding MIDI key, and the con-
trols are automatically displayed for that sound.
The controls offered for each band of the EQ are as follows:
▪
Level: Sets the volume cut or boost applied to the frequency band.
▪
Freq: Sets the central frequency of the band.
▪
Width: Sets the width, or size of the band.
Filters
The filters also shape the frequency content of the sound, but they are a lot coarser and
are thus mainly used as an effect.
The filter controls are similar to the EQ controls in that certain presets give the option for
Global and per Drum/Loop filters.
Global and Drum specific filter.
Activating and selecting the filters is handled in the same way as the EQs.
The two filters on offer are:
▪ A
4-pole Highpass: used to remove low frequency signals. The signal is reduced at a
rate of -24dB per octave below the cutoff frequency.
▪ A 4-pole Lowpass: used to remove high frequency signals. The signal is reduced at a
rate of -24dB per octave above the cutoff frequency.
The cutoff frequency for each is controlled with the CUTOFF knob. The RESONANCE knob can
be used to add a gain boost at the cutoff frequency.
Using the Instruments
Common Controls
DAMAGE - Manual - 26