User Manual

3.1.3 Volume Envelope
Global Amp Envelope on the Main Page.
On
the right side of the Main page there is an ADSR envelope for modulating the instru-
ment volume. This envelope is triggered with every note and can be used to shape the vol-
ume of the played note. The four controls for the envelope are as follows:
▪
ATTACK: Controls the attack time, or fade-in, of the envelope.
▪
DECAY: Controls the decay time, which is the amount of time it takes to get from the
maximum volume to the volume set by the SUSTAIN control. The decay phase occurs
after the attack phase is finished.
▪
SUSTAIN: Sets the level at which the envelope will rest after the decay phase is finish-
ed. The sustain phase will last for as long as the key is pressed.
▪
RELEASE: Sets the fade-out time that occurs after the triggering note is lifted (or re-
leased).
For the Damage Hits instrument, you have access to two separate envelopes, one for the
main hit, and one for the tail layer. To access the different sets of controls, just click on
the HIT or TAIL tabs above and below the four knobs.
Using the Instruments
Common Controls
DAMAGE - Manual - 23