User Manual

Table Of Contents
(5) MAP section
The MAP section contains the parameters defining the key and velocity ranges of the Zone.
Parameter Description
KEY LO (Lowest Key) Sets the lowest note (key) of the focused Zone. Alternatively, you can drag
the left border of the Zone in the Map.
KEY HI (Highest Key) Set the highest note (key) of the focused Zone. Alternatively, you can drag
the right border of the Zone in the Map.
VEL LO (Lowest Velocity) Defines the lowest velocity of the focused Zone. Alternatively, you can drag
the lower border of the Zone in the Map.
VEL HI (Highest Velocity) Defines the highest velocity of the focused Zone. Alternatively, you can
drag the higher border of the Zone in the Map.
14.5.7.1 Editing Your Zones on the MASCHINE MIKRO Controller
At the bottom of the display, the Zone settings allow you to adjust how each Zone should be
played back.
The Zone settings on the controller.
The various parameters always display the values for the focused Zone.
The parameters available in the Zone settings are spread over five pages. To access these pa-
rameters do the following:
1. If it’s not done already, press SAMPLING to enter Sampling mode and press NAV +
pad 16 to select the ZONE page. You can also hold NAV and turn the Control encoder.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE MIKRO MK2 - Manual - 660