User Manual

→
The Scene is selected and the Loop Range is set to this Scene.
Setting the Loop Range to Several Scenes
To set the Loop Range to several consecutive Scenes, do the following:
1. Press and hold SCENE to enter Scene mode (you can pin it by pressing CONTROL).
2. Press and hold the pad corresponding to the start Scene.
3. While holding the first pad, press the pad corresponding to the end Scene.
→
The start and end Scenes along with all Scenes in-between are included in the Loop
Range and played one after the other in a loop.
If you further hold the pads for both the start and end Scene, you can press any pad in-
between to select a particular Scene without changing the Loop Range! Usual rules for
Scene jumps will apply (see section ↑13.3.2, Jumping to Other Scenes).
The start and end Scenes can be in different Scene banks. Simply press SHIFT + Left/
Right Arrow button to switch to the desired Scene bank before you hold the pad of the start
or end Scene.
Quickly Setting the Loop Range to the Entire Project
You can quickly select all Scenes in one go:
►
Press SCENE + F1 (ALL) to include all available Scenes in the Loop Range.
If you want to set the Loop Range back to a particular Scene, press SCENE + the desired pad
as described above.
You can also do this at any time without switching your controller to any particular mode:
Creating a Song Using Scenes
Playing with Scenes
MASCHINE MIKRO MK2 - Manual - 589