User Manual

◦ If playback is off the playhead immediately jumps to the beginning of the selected
Scene. If playback is on the playhead jumps according to the Perform Grid settings.
For more info on the Loop Range see section ↑13.3.1, Selecting a Loop Range. For more
info on the Perform Grid settings see section ↑13.3.2, Jumping to Other Scenes.
13.2.2.1 Selecting Scenes and Scene Banks on the MASCHINE MIKRO Controller
Selecting a Scene Bank
To select a Scene located in another Scene bank than the one currently selected, you fist need
to select that other Scene bank:
1. Press and hold SCENE to enter Scene mode.
2. Press SHIFT + Left/Right Arrow button to select the previous/next Scene bank, respective-
ly.
If the last Scene bank is selected and not empty, pressing SHIFT + Right Arrow button will
create a new, empty Scene bank — see section ↑13.2.5, Creating and Deleting Scene
Banks for more info.
Selecting a Scene
►
To select a Scene in the current Scene bank, press SCENE + the dim lit pad correspond-
ing to this Scene.
Upon your selection, the following happens:
▪ The Pattern Editor displays the Pattern corresponding to the Clip for the focused Group in
this Scene. If there is no Clip for the focused Group in the Scene you have just selected,
the Pattern Editor is empty.
▪ The Loop Range is set to the selected Scene — see section ↑13.3.1, Selecting a Loop
Range.
▪ If playback is off the playhead immediately jumps to the beginning of the selected Scene.
If playback is on the playhead jumps according to the Perform Grid settings — see sec-
tion ↑13.3.2, Jumping to Other Scenes.
Creating a Song Using Scenes
Managing Scenes
MASCHINE MIKRO MK2 - Manual - 570