User Manual

Table Of Contents
3. While you are holding PATTERN, press SHIFT + Left/Right Arrow buttons to select the de-
sired Pattern bank, then press the desired pad to select the Pattern you want to use in
that Scene.
If you have pressed a dim lit pad, a Clip referencing this Pattern is inserted into the se-
lected Scene. If you have pressed an unlit pad, a new empty Pattern is automatically cre-
ated and referenced by a new Clip in the selected Scene. In both cases, any Clip previ-
ously existing for that Group in the Scene will be replaced.
Furthermore, the following happens:
In the Arranger the Clip displays the name and color of the Pattern it is referencing.
The Clip is inserted at the beginning of the Scene. If the Clip is longer than the Scene,
the Scene is extended to include the entire Clip. If the Clip is shorter than the Scene, the
Clip is automatically repeated in order to fill the entire Scene.
The corresponding Pattern will now be played by that Scene.
Additionally this Pattern is loaded in the Pattern Editor, ready to be modified.
For further information regarding the Pattern mode, please refer to section 7.7, Managing
Patterns.
Removing a Clip
Removing a Clip is also done in Pattern mode:
To remove the Clip for the selected Group from the selected Scene, press PATTERN +
SHIFT + F3 (REMOVE).
The Clip is removed from the Scene:
The corresponding Pattern will not be played by that Scene anymore.
The Pattern itself is left untouched.
If the Clip was the longest one in the Scene, the Scene will automatically shrink to the
next longest Clip.
Creating a Song Using Scenes
Arranger Basics
MASCHINE MIKRO MK2 - Manual - 563