User Manual

Table Of Contents
The Filter panel in the Plug-in Strip.
Main Page
The Filter in the Control area: Main page.
Parameter Description
TYPE Section
Mode Here you can select between four different filter modes: LP (low-pass), BP
(band-pass), HP (high-pass), and Notch. Depending on the mode selected, the
following parameters vary as indicated.
FREQ Section
Cutoff Controls the cutoff frequency of the filter.
Resonance Controls the amount of resonance, i.e. the amount of amplification near the
cutoff frequency. It is not available with filter mode Notch.
MOD Section
Amount This defines how much the Filter gets modulated by the modulation source.
Effect Reference
Filtering Effects
MASCHINE MIKRO MK2 - Manual - 515