User Manual

Table Of Contents
9. Turn the Control encoder to assign that auxiliary output to the desired send effect. In ad-
dition to the usual outputs available in the field, you will find all the Sounds and Groups
with an Effect Plug-in loaded in their first Plug-in slot see 11.3.1, Step 1: Set Up a
Sound or Group as Send Effect above. For each Sound, the entry shows the Group letter
and number followed by the Sound number (in the example underneath we selected the
entry A1:S1-1 for the AUX 1 output).
10. Press the Right Arrow button to select 2/6: LEVEL, and turn the Control encoder to adjust
the level of the signal sent through the auxiliary output.
The signal of each auxiliary output is taken by default after the main output level control
has been applied. This can be changed via the 3/6: ORDER parameter of the same page. For
more information, please see section 8.1.3, Setting Up Auxiliary Outputs for Sounds and
Groups.
You can repeat the process to route more Sounds/Groups to the same send effect, or route the
same Sound/Group to another send effect send using AUX 2.
11.3.3 A Few Notes on Send Effects
When working with send effects, please keep in mind the following:
You cannot send the Master output to send effects.
You cannot send a send effect’s output to itself, nor the output of a Group to one of its
own Sounds.
However, you can:
Chain several Sounds configured as send effects by sending the output of a send effect
into another send effect using the method described above (see 11.3.2, Step 2: Route
Audio to the Send Effect).
Using Effects
Creating a Send Effect
MASCHINE MIKRO MK2 - Manual - 492