User Manual

Table Of Contents
7. Turn the Control encoder to set SUBTYPE to EFFECT.
8. Press F2 (LIST) to show the filtered list of results.
9. Turn the Control encoder to select an effect and press the Control encoder to load it.
The selected effect is loaded in a new Plug-in slot and directly starts to process your ex-
ternal audio! By pressing CONTROL or SHIFT + BROWSE again you can switch back to
Control mode and adjust the effect.
11.3 Creating a Send Effect
Sometimes you may want to have a classic send effect, for example a reverb which can be
shared by multiple sound sources. To make use of a send effect, you need to:
Step 1: Set up a Sound or Group as send effect. This is done by loading an effect into its
first Plug-in slot: 11.3.1, Step 1: Set Up a Sound or Group as Send Effect.
Step 2: Route a portion of the desired audio signals from their original Sounds and
Groups to that send effect. This is done via the Output properties of the corresponding
Sounds and Groups: 11.3.2, Step 2: Route Audio to the Send Effect.
11.3.1 Step 1: Set Up a Sound or Group as Send Effect
The procedure to set up a Sound or Group as a send effect is straightforward: You just need to
load an effect into its first Plug-in slot MASCHINE will take care of the rest and make it
available as destination for other channels of your Project!
The procedure in Arrange view is described here. You can also do this in Mix view see
section 11.1.1, Adding an Effect.
In this example we will use an empty Sound:
Using Effects
Creating a Send Effect
MASCHINE MIKRO MK2 - Manual - 486