User Manual

Table Of Contents
The Nudge Grid is not indicated in the Event area of the Pattern Editor.
7.1.7.1 Adjusting the Step Grid and the Nudge Grid on the MASCHINE MIKRO Controller
You can enable/disable the Step Grid and adjust the Step Grid and Nudge Grid resolution from
your controller.
Enabling or Disabling the Step Grid
To enable or disable the Step Grid:
1. Hold GRID to enter Grid mode. You can also pin Grid mode in order to keep it active when
you release GRID (see 2.3.5, Pinning a Mode on Your Controller).
2. Press F3 (STEP) to access the Step and Nudge Grid settings.
3.
Use the Left/Right Arrow button under the display to select the ENABLE parameter at the
bottom of the display:
4. Turn the Control encoder to set the parameter value to ON (Step Grid enabled) or OFF (Step
Grid disabled).
5. If you have pinned Grid mode at the first step, press the lit GRID button to leave Grid
mode.
Adjusting the Step Grid
To change the Step Grid resolution:
1. Hold GRID to enter Grid mode.
2. Press F3 (STEP) to access the Step and Nudge Grid settings.
Working with Patterns
Pattern Basics
MASCHINE MIKRO MK2 - Manual - 254