User Manual

1. Hold GROUP and press the Right Arrow button repeatedly to navigate to the last Group
bank.
2. While holding GROUP, press the dimmed white pad after all lit pads.
→
A new empty Group is created after the existing Groups with the default name and color.
Creating Groups via the Select Mode
You can also use the Select mode to create Groups from your controller:
1. Press and hold SELECT to enter Select mode. You can also pin the Select mode by press-
ing SELECT + CONTROL: You can then release SELECT: Your controller will stay in Select
mode until you press SELECT again. See section ↑2.3.5, Pinning a Mode on Your Control-
ler for more information.
2. Press F1 to select QUIET.
3. Press GROUP.
4. Press the Right Arrow button repeatedly to navigate to the last Group bank.
5. Press the last half-lit pad to create a new empty Group.
4.3.2 Loading Groups
You can load a readymade Group from the Browser or from your operating system. The Group
can be included in the MASCHINE Library or any EXPANSION PACK but it can also be a
Group you have created yourself and saved for later use.
You have many methods at your disposal to load a Group:
▪ Drag and drop: Select the desired Group in the Browser or Group file in your operating sys-
tem and drag it onto the Group List:
◦ Drag it onto an existing Group to replace this Group in the Group List.
◦ Drag it between two Groups to insert it between both.
◦ Drag onto the “+” at the end of the Group List to append it to the existing Groups.
▪ Double-click: Double-click the Group in the Browser or the Group file in your operating
system to replace the focused Group in the Group List.
Managing Sounds, Groups, and Your Project
Managing Groups
MASCHINE MIKRO MK2 - Manual - 151