User Manual

4.4.4 The SYNC (MASTER) Button in Capture Mode
When Capture mode is active, the SYNC (MASTER) button will both control and indicate the
Sync and Master states of the capture source Deck. This is mostly for the case where you real-
ize that the capture source Deck is not synced to the Master. It gives you an opportunity to
sync the Deck without having to take your hands of the controller; for example, if Sync is on for
the Remix Deck but Sync is off for the capture source Deck, the SYNC (MASTER) button will
turn dim when you activate Capture mode — this shows you that the capture source Deck is
not synced to the Master.
►
If you press the SYNC (MASTER) button, Sync will be enabled on the capture source
Deck and the button will light up brightly.
►
Using the SHIFT button, you can do the same with the Master state of the capture source
Deck: in Capture mode, the SYNC (MASTER) button will be dim if the capture source
Deck is not the Master. By pressing the button (while holding SHIFT), you can toggle the
Master state of the capture source Deck.
4.4.5 Activating a Loop on the Capture Source Deck
►
By pressing the encoder knob, you can activate or deactivate the Loop.
When the Loop is active, the Loop Size will blink on and off on the display.
4.4.6 Loop Move and Beat Jump on Capture Source Deck
►
By rotating the encoder knob while the Loop is engaged, you change the Loop size by
moving the Loop Out marker. In addition, by holding SHIFT while rotating the encoder
knob, you can move the Loop in increments of the Loop Size.
►
With a deactivated loop, by holding SHIFT and rotating the encoder knob you can per-
form a beat jump in the amount of the Loop Size.
With the loop deactivated (the Display is not blinking), you can quickly find the part of
the Source Track you want to capture by holding SHIFT and turning the encoder knob.
TRAKTOR KONTROL F1 Reference
Capture Mode
TRAKTOR KONTROL F1 - Manual - 93