User Manual

7-segment display Beats Bars/Note Lengths
32 32 beats 8 bars
16 16 beats 4 bars
8 8 beats 2 bars
4 4 beats 1 bar
2 2 beats Half-note
1 1 beat Quarter-note
.2 Half-beat Eighth-note
.4 Quarter-beat Sixteenth-note
.8 Eighth-beat Thirty-second-note
.16 Sixteenth-beat Sixty-fourth-note
The Loop Size is the same as the capture length. In other words, if the Display shows "4" (Loop
Size = one bar) when you capture to a pad, that pad will then contain 4 beats (one bar) from
the Source Track.
4.4.3 Setting the Capture Size
Once you have activated Capture mode, you can change the capture length with the encoder
knob:
►
With Capture mode active, rotate the encoder knob to set the capture size.
When pressing the encoder knob at this point, a loop of the specified length will be acti-
vated in the capture source Deck. Pressing the encoder knob again will deactivate the
loop. Activating a loop inside the Track Deck before capturing can be handy for transi-
tions between elements of a Remix, or between track transitions in your mix.
The available capture length values can be seen on the table above. The Display shows the
current capture length value.
TRAKTOR KONTROL F1 Reference
Capture Mode
TRAKTOR KONTROL F1 - Manual - 92