User Manual

►
Hold SHIFT and press the encoder knob.
If you are saving a pre-existing Remix Set, you will then be given the option to Overwrite, Re-
name, or Cancel on the TRAKTOR software. You can choose your desired option using the en-
coder knob:
►
Press the encoder knob to activate your selected option.
On the other hand, if the contents of the Remix Deck were not loaded from a Remix Set (in
other words, the content of the Remix Deck was sampled on the fly or populated with individu-
al files from the Collection), then a new Remix Set will be saved when you trigger this function.
The Remix Set will have the following name: "Remix Set" followed by the date and time stamp,
indicating exactly when you save the Remix Set.
Assigning the F1 to a Different Remix Deck / Changing the Focus on the Controller
You can change the Remix Deck controlled by the F1 with the encoder knob:
►
Hold SHIFT and rotate the encoder knob.
Note that this is only possible if there are two or more Decks set to Remix Deck. When holding
SHIFT and rotating the encoder knob, the F1 indicates which Remix Deck is being controlled
in two ways:
▪ 7-segment display: The display shows the name of the controlled Deck by showing the letter
"d" followed by the letter of the Deck. For example, when controlling Deck C, "dC" will be
shown in the display. When controlling Deck D, "dd" will be shown.
▪ Pads: You can readily see which Deck is the controlled Remix Deck by glancing at the F1's
pads. The 16 pads are divided into four 2x2 squares. Each square represents a Deck. The
four upper-left pads, for example, indicate Deck A, the four upper-right show Deck B, and
so on. When you change the Deck assignment with the encoder knob, the quadrant corre-
sponding to the newly-selected Deck will begin to flash rapidly.
TRAKTOR KONTROL F1 Reference
Performance Mode
TRAKTOR KONTROL F1 - Manual - 77