User Manual

Setting / Removing Steps
1. Press a pad to set that step in the sequence.
⇨ When the playhead reaches the step, the sample will play back.
2. Pressing the pad again removes the step from the sequence.
Switching the Sample Focus
►
Press any of the four STOP buttons to focus a specific sample.
Defining the Number of Steps
►
Turn the encoder to increase / decrease the number of steps of the sequence.
Selecting another sample within the column
►
Hold SHIFT and turn the encoder to select another sample stored in the same column of
the Remix Set. If no other sample is stored, turning the encoder has no effect.
Controlling Volume
►
Move any of the four volume faders to control the volume of the corresponding sample.
Using SWING
1. Press the SHIFT + CAPTURE to increase the swing value.
2. Press the SHIFT + TYPE to decrease the swing value.
→ The swing value in percentage is shown in the digital display.
Applying Filter
1. Turn any of the FILTER knobs to set the filter cutoff and to apply the filter to the corre-
sponding sample.
2. Return the knob to its middle position to disengage the filter.
Tutorials and Workflows
Using Step Sequencer Mode
TRAKTOR KONTROL F1 - Manual - 61