User Manual

►
Turn the encoder knob until you see "4." This means that four beats will later be captured
from the capture source Deck.
When pressing the encoder knob at this point, a loop of the specified length will be acti-
vated in the capture source Deck. Pressing the encoder knob again will deactivate the
loop. Activating a loop inside the Track Deck before capturing can be handy for transi-
tions between elements of a Remix, or between track transitions in your mix.
Capturing into a Pad
If you want the Sample start to snap to the capture source Deck's Beatgrid, make sure the
Snap function (S) is active in the software's Main section. We recommend to have the Snap
function always active when capturing Samples.
Making sure Snap (S) is active in the MAIN area of the software.
Wait for a moment shortly before a downbeat in the track of the capture source Deck, then:
►
Push the pad where you want to capture the loop.
→
A Sample of the previously specified length will now be captured from the Track Deck in-
to the pad.
1. Push CAPTURE (DELETE) to exit Capture mode.
2. Now hit the target pad to get it to start playing.
3. Repeat the process (from "Determining Capture Length" to "Capturing into a Pad") several
times, with different loop lengths and from different parts of the track — enjoy!
Tutorials and Workflows
Making Your Own Remix Set
TRAKTOR KONTROL F1 - Manual - 53