User Manual

16.4.3 Live Slicing
Live Slicing is a quick and intuitive way to add slices to a sample using the pads on your con-
troller. The first pad is used to trigger the sample and the subsequent pads are used to add
slice points as required. If necessary, the start and end points of the slices can then be fine-
tuned using Edit mode.
Live Slicing is only available from your MASCHINE controller.
16.4.3.1 Live Slicing Using the Controller
To manually add Slices to a sample using the pads on your controller:
1. Press the SAMPLING button to enter the Sampling page.
2. Press Button 3 to select SLICE to open the SLICE tab.
3. Turn Knob 1 to select Manual mode.
▪ Pad 1 will begin to flash to indicate that the first Slice can be added.
4. Press Pad 1 to add the first Slice to the sample.
▪ Playback of the sample will begin and the next pad will begin to flash to indicate that the
next slice point can be added.
5. Press Pad 2 to add the second slice point.
6. Continue to press subsequent pads as they flash to add more slices.
→ When playback of the sample stops you may fine-tune the start and end points of your
slices by entering EDIT mode.
Press SHIFT + MUTE if you want to stop playback of a long sample.
Press SHIFT + Button 7 and 8 to access each bank of Slices.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE - Manual - 845