User Manual

▪ Learn: Allows you to map the control to the desired knob/button/key by simply turning/
pressing/hitting the relevant input parameter.
◦ The Learn function is available for MIDI Input controllers and HID controls (key
board, mouse etc.)
◦ Learn mode stays active until you press this button again. This allows you to assign
several controls in one go.
◦ Do not forget to disable Learn when you are finished in order to avoid undesired as
signments.
▪ Assignment Drop-Down menu: Here you can manually assign a Control.
◦ This is the only way to assign a MIDI output controller or HID (keyboard, mouse
etc.). On the first level of the drop-down list you choose the MIDI channel (1-16).
If no assignment is working, check which MIDI channel your MIDI controller or HID
is set to for sending and receiving MIDI.
▪ Reset: This button deletes the current assignment.
▪ Comment: You can enter a comment in this field, which is stored with the Control as
signment.
13.19.5 Mapping Details
Fig. 13-5 The Mapping Details section.
▪ Modifier: A Modifier allows you to define a Control, either a MIDI message or keyboard
key (depending on the mapping), to operate another Control depending on one (or even
two) condition(s).
◦ Each Modifier functions as an If command. In order to execute the Control, each
Modifier's Value condition must be met, and those Modifiers and Value conditions
are set here. Once they have been set, they will appear for that Control in the As
signment table under the columns Mod1 and Mod2 (e.g. M1=0).
A Modifier is always restricted to the mapping it is part of. You cannot use a Modifier for
anything outside of a mapping. Each mapping can have up to eight Modifiers (M1 to M8).
Preferences
Controller Manager
TRAKTOR 2 - Application Reference - 165