User Manual

Fig. 9-10 Master Clock Panel — MIDI Clock Send.
► Click the Metronome symbol on the far left of the Global section to switch to Master
Clock panel.
► To send a MIDI Clock Start message for syncing the slaved devices, click the Start/Stop-
button. Clicking it again sends a MIDI Clock Stop message.
► Pressing SYNC, sends a MIDI Clock Stop message instantly followed by a MIDI Clock
Start message to re-sync the slaved devices.
► Before you can send the MIDI Clock signal you have to activate Send MIDI Clock in Prefer
ences > MIDI Clock.
► To match the beats between the sending and the receiving TRAKTOR application, the
MIDI Clock sending offset must be adjusted in the sending application in Preferences >
MIDI Clock.
Normal MIDI Clock Messages are sent continuously as soon as the preferences checkbox
"Send MIDI Clock" is activated.
9.3 Effect Panels
TRAKTOR has four individual Effect Units. Their control panels are located on the left and
the right side of the Global section. For switching from either the Master Clock or the Au
dio Recorder to the respective Effect panel, click on the tabs labeled FX on either end of
the Global section.
You can choose between 2 or 4 visible Effects. To switch from 2 Effects mode (default) to
4 Effects mode, go to Preferences > Effects > FX Unit Routing.
Each of the Effects Units can be inserted into any of the TRAKTOR Decks individually or
into more than one Deck at a time by clicking on the FX Assign buttons found in the mixer
strip of each Deck.
TRAKTOR’s effects are insert effects by default, but you can also use them as send ef
fects.
Using the Header and Global Sections
Effect Panels
TRAKTOR 2 - Application Reference - 119