User Guide

RAM Mounting Systems
RAM Mounting Systems
8410 Dallas Ave S
Seattle, WA 98108
Phone: [phone]
Fax: [phone]
www.rammount.com
[e-mail]
Seat bolt range must have a center to center distance
between 9” and 19”.
Your seat bolts should pass into the floorboard at 90-degrees
from the floorboard surface.
Inner Seat Mounting Bolts
9”
19”
1. Seat Bolt Orientation & Distance
2. Console Clearance
Center Console
7/8”
5”
3. 90-Degree Seat Bolts
Floorboard
90°
Seat Bolt
Direction
Bolt direction may vary by up to 10-degrees, but any
further variation will result in the Tele-Pole interfering
with the dashboard or passenger seating area.
RAM® Universal No-Drill™ Laptop Mounting System
Vehicle Compatibility Guide
To determine if the RAM® Universal No-Drill™ Laptop Mounting System will install properly in your vehicle,
carefully read and review the steps in this guide, while checking measurements in your vehicle.
Floorboard
Depending on your vehicle, you may install
the RAM® Universal No-Drill™ Laptop Mount
at one of these two seat bolt orientations on
the passenger side:
Orientation A:
Front Seat Bolts
Orientation B:
Side Seat Bolts
Passenger Seat
7/8”
This spacing is important for up to 5” in front of the center of the bolt.
Center
Console
If you are using Orientation B from Step 1, the distance between the seat bolts and center console must be at least 5”.
No matter what orientation you choose, the lower pole must be
positioned closest to the front inner corner of the passenger
seat against the console/transmission hump.
Passenger Seat
Identify the inner seat bolt closest to the center console. The distance between the center of this bolt and the console must be
at least 7/8”. This spacing is important for up to 5” in front of the center of the bolt.
*This mount is not compatible with vehicles that have seat hooks instead of bolts.