User's Manual

Appendix A Status Codes
© National Instruments Corporation A-19 NI-DAQ FRM for PC Compatibles
–10698 timebaseConflictError You cannot use this combination of scan
and sample clock timebases for this
board.
–10699 polarityConflictError You cannot use this combination of scan
and sample clock source polarities for
this operation and board.
–10700 signalConflictError You cannot use this combination of scan
and convert clock signal sources for this
operation and board.
–10701 noLaterUpdateError The call had no effect because the
specified channel had not been set for
later internal update.
–10702 prePostTriggerError Pretriggering and posttriggering cannot
be used simultaneously on the Lab and
1200 series devices.
–10710 noHandshakeModeError The specified port has not been
configured for handshaking.
–10720 noEventCtrError The specified counter is not configured
for event-counting operation.
–10740 SCXITrackHoldError A signal has already been assigned to
the SCXI track-and-hold trigger line, or
a control call was inappropriate because
the specified module is not configured
for one-channel operation.
–10780 sc2040InputModeError When you have an SC-2040 attached to
your device, all analog input channels
must be configured for differential input
mode.
–10781 outputTypeMustBeVoltageError The polarity of the output channel
cannot be bipolar when outputting
currents.
–10782 sc2040HoldModeError The specified operation cannot be
performed with the SC-2040 configured
in hold mode.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description