User's Manual

Appendix A Status Codes
© National Instruments Corporation A-15 NI-DAQ FRM for PC Compatibles
–10611 badDirOnSomeLinesError Some of the lines in the specified
channel are not configured for the
transfer direction specified. For a write
transfer, some lines are configured for
input. For a read transfer, some lines are
configured for output.
–10612 badLineDirError The specified line does not support the
specified transfer direction.
–10613 badChanDirError The specified channel does not support
the specified transfer direction.
–10614 badGroupDirError The specified group does not support
the specified transfer direction.
–10615 masterClkError The clock configuration for the clock
master is invalid.
–10616 slaveClkError The clock configuration for the clock
slave is invalid.
–10617 noClkSrcError No source signal has been assigned to
the clock resource.
–10618 badClkSrcError The specified source signal cannot be
assigned to the clock resource.
–10619 multClkSrcError A source signal has already been
assigned to the clock resource.
–10620 noTrigError No trigger signal has been assigned to
the trigger resource.
–10621 badTrigError The specified trigger signal cannot be
assigned to the trigger resource.
–10622 preTrigError The pretrigger mode is not supported
or is not available in the current
configuration, or no pretrigger source
has been assigned.
–10623 postTrigError No posttrigger source has been
assigned.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description