User's Manual

Appendix A Status Codes
NI-DAQ FRM for PC Compatibles A-8
© National Instruments Corporation
–10256 comPortOpenError There was an error in opening the
specified COM port.
–10257 baseAddressError Bad base address specified in the
configuration utility.
–10258 dmaChannel1Error Bad DMA channel 1 specified in the
configuration utility or by the operating
system.
–10259 dmaChannel2Error Bad DMA channel 2 specified in the
configuration utility or by the operating
system.
–10260 dmaChannel3Error Bad DMA channel 3 specified in the
configuration utility or by the operating
system.
–10261 userModeToKernelModeCallError The user mode code failed when calling
the kernel mode.
–10340 noConnectError No RTSI signal/line is connected, or the
specified signal and the specified line
are not connected.
–10341 badConnectError The RTSI signal/line cannot be
connected as specified.
–10342 multConnectError The specified RTSI signal is already
being driven by a RTSI line, or the
specified RTSI line is already being
driven by a RTSI signal.
–10343 SCXIConfigError The specified SCXI configuration
parameters are invalid, or the function
cannot be executed with the current
SCXI configuration.
–10344 chassisSynchedError The remote SCXI unit is not
synchronized with the host. Reset the
chassis again to resynchronize it with
the host.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description